Potentiostat (0–10 V)
Connect to the potentiostat Nano. Set output voltage in volts (0–10). Protocol defaults to V{mV} (e.g., V2500).
Not connected
Ready. Click “Connect”.
Master / Slave (24 current sources)
Send a 24-character 0/1 pattern (no spaces) + CR/LF to the Master. Live current readout below. If your firmware streams current automatically, set Mode to Push; otherwise Poll will send READ? at the chosen rate.
Not connected
Packet format:
000...111\r\n
Lens Voltages (0–5 V)
Uses the same connection as the Master/Slave panel. Connect there first.
Using Master/Slave port
Ready. Click “Connect”.
Picomotor Controller (8742)
Jog four directions. Default commands use channel 1=X, 2=Y with New Focus–style <axis>PR <steps>. Adjust templates if your unit differs.
Not connected
Command templates (edit if needed)
Lines are terminated with \r\n. If your 8742 expects different opcodes, just edit these boxes.
Ready. Click “Connect”.